PremiumLine full-body emergency shower – B-SAFETY with eye shower, for floor mounting

The free-standing industrial emergency showers are used whenever wall mounting of the shower is not possible or if a central point of contact for first aid is to be created. Their use is also sensible in large halls and production facilities. A major advantage is the good visibility of the shower from all sides. The free-standing emergency showers can be adapted to the on-site requirements with a large selection of options as required.

The B-SAFETY body emergency showers of the PremiumLine series are made of stainless steel and are just as suitable for use in laboratories and research as for harsh use in industry. The polished stainless steel surface is not only resistant to many chemicals, but also offers a modern design for laboratories and cleanrooms.

The body emergency showers are equipped with the B-SAFETY high-performance shower head, which not only meets the requirements of ANSI Z358.1 and DIN EN 15154, but is also self-draining, largely limescale- and maintenance-free, as well as very robust and corrosion-resistant. The limited, uniform and above all soft water jet is optimised for rinsing chemicals from the skin. With the enclosed safety sign according to DIN EN ISO 7010 and ASR A1.3, the B-SAFETY emergency shower is identified and visibility is improved. The recognition distance is 15 metres.

– Integrated PremiumLine safety eye shower with two 45° spray heads, mounting height 970 mm, alignment of the eye shower freely selectable on site
– Two wide-spraying high-performance spray heads made of stainless steel, polished, angled at 45°, with plastic spray plate, low-limescale, including rubber protection and tight-fitting dust cover with flip-open mechanism, mounted via a distributor fork
– Standpipe 1 1/4-inch made of stainless steel, three-piece, polished, with upper and lower water connection 1 1/4-inch female thread, total height 2300 mm
– Base with 4 mounting holes made of stainless steel, polished, diameter 200 mm
– Wall shower arm 3/4-inch made of stainless steel, polished, projection 630 mm, connecting piece made of stainless steel, for quick on-site assembly and easy alignment of the shower arm
– Ball valve 3/4-inch made of stainless steel, with quick-assembly system and pull-rod actuation, pull rod with ring handle made of stainless steel, polished, length 700 mm
– Including upper and lower water connection 1 1/4-inch female thread for installation in circulation pipes, plug 1 1/4-inch made of stainless steel
– Connecting pipe made of stainless steel for easy assembly and alignment of the shower, polished, water connection 3/4-inch male thread
– Ball valve 1/2-inch made of stainless steel, with PUSH-lever operation, operating plate made of stainless steel, polished, length 130 mm, with large PUSH signal, photoluminescent according to DIN 67510
– Integrated automatic flow regulator 50 litres/minute for a standard-compliant spray pattern at a specified working range of 1.5 to 3 bar flow pressure
– According to BGI/GUV-I 850-0, DIN 1988 and DIN EN 1717, ANSI Z358.1-2014, DIN EN 15154-1:2006, DIN EN 15154-2:2006 and DIN EN 15154-5:2019. DIN-DVGW tested and certified