The following information is an important aid for proper planning: Connect modules are available as:
standard modules and
(see photos above this text). Standard modules have perforated profile rails on the left and right for holding add-on elements (e.g. shelves, trays, worktops etc.), which are easily attached without tools (see below). Add-on elements can be easily suspended in the 50 mm grid at the required height, and secured with special ANKE locking clips to protect against unintentional detachment.
Extension modules have perforated profile rails (see above) on one side, and connection lugs on the other side for attaching extension and standard modules (see below).
Standard modules have perforated profile rails on the left and right for holding add-on elements (e.g. shelves, trays, worktops etc.), which are easily attached without tools (see below). Add-on elements can be easily suspended in the 50 mm grid at the required height, and secured with special ANKE locking clips to protect against unintentional detachment.
Standard modules are connected with the required number of
extension modules in this manner to form rows. This creates a
robust industrial partition wall, which divides the
room and also offers additional uses, which are shown in the
Stability: Flat, oval tube feet provide the necessary
stability. As standard, the standard module is supplied with
two flat oval tube feet, the extension module with one flat
oval tube foot. The Connect Modules are mounted on these feet
at the centre (comp. foot M). Using levelling screws, the
Connect Modules can be levelled horizontally. Other versions
of feet can be supplied to suit the respective
mounted at the center
mounted on one side
screwed to the floor
Please note that to ensure stability,
add-on elements may not protrude out over the feet.
Shelves with a depth of 450 mm can only be used in
conjunction with single sided foot configuration. Hook-in
worktops (depth 500 mm) may only be suspended at a max.
height of 1100 m, measured from floor to worktop.
90° corner combinations
90° corner combination modules can also be used with ANKE
Connect to create cubicles. One corner combination consists
of 2 wall modules, which are connected using a 90° corner
connection fitting. The corner is covered on the front and
back with screens. The cavity created in the process can be
used as a cable duct, etc. Plug sockets, network sockets,
etc. can be integrated in the screens.
Corner combination A consists of 2 standard modules, which
are set-up at a 90° angle. Extension modules can be attached
to both sides. Corner combination B consists of one standard
module and one extension module. This corner combination can
be attached to existing rows of Connect Modules, as the
extension module in this corner combination is fitted with
connection lugs on one side (see description for extension